Centroid Community CNC Support Forum

I close the power supply , close the drive and evertything is to 00000 restart cnc12 , recove the reset , push the jog button and the motor start running non stop , i stop it by pushing to stop . a window open saying that all the home are set . first, all the home are unplug from the card . and Al00...

Delta manuel .

Keith
The delta drive is to factory reset.
Load the number (gain button section )
start cnc12.
try to move the axe , it move very fast ,reverse the movement and the drive stop .
drive show Al009

Nothing work . I did all and nothing .

Hi about acorn setup number I find those setup on the web somewhere , is that you mean by acorn setup number ? I reset the drive to factory , I input the number , I plug the step and dir into the db25 at 2 and 3 . I enable the db25 in cnc12. Good news no axe are moving at all . the axe that I was wo...

Question to cnckeith

enter acorn delta parameters
confirm correct parameters
what is that and where to find it ?

new pic.

New picture

What exact model ASDA-B2 drives do you have? It will say on the nameplate sticker. Please post a picture of the connector and nameplate sticker if you can. I am curious because all of Delta's documentation for ASD-B2-xxxx-B (standard spec) drives shows a 44 pin CN1 connector. The ASD-B2-xxxx-F spec...

my delta drive are working ok . with the delta cable I'm able to change speed and jog direction . the communicatiion delta drive with centroid acorn that is not working at all. I use the acorn wiring for the asda-b2 (by the way it has a 50 pins on the b2 model ). it been a week that is going around ...