Centroid Community CNC Support Forum

Hi Marty, looks like I will not get a answer I need from LMS. "Dave Well, we don’t know to the level you ask. We know that it works, and how to connect it. It’s amazing that none of the other purchasers needed that information, right? They just hooked it up and used it". so yeah I just don...

Thanks Mike,

I will send this info to LMS and hopefully get a answer on the card I just bought from them.

~Dave

Hi Marty, Here are some replies from LMS.. "I have no idea, but what is your concern? You will have a common ground." "The 0-10V signal is coming FROM your Centroid Acorn Board. How would isolation work?" I am not sure what to say back to him as I am kind of lost myself. would i ...

Hi Marty,

here is a link to the card on their website. i was not able to post the file here for some reason.


https://protect-eu.mimecast.com/s/7abNC ... lmscnc.com

~Dave

Hello all, Well after ordering KBSI-240D card I found a card that LMS sells that is made just for my lathe. https://imageshack.com/i/pmuEE3h6j This CNC spindle control kit consists of a small circuit board that replaces the circuit board with the speed control potentiometer, plus a replacement chip ...

Hi Marty,

It looks like I can buy a KBSI-240D card to be able to control the spindle motor. I should also be able to use the relay board that came with the Acorn board for use of forward and reverse. Someone please correct me if I am wrong.

Thanks
Dave

Hello All, I was wondering if anyone can help me figure out if I am able to use the motor that can with the lathe or if I would need to buy a inverter duty three phase motor and a sensorless vector VFD. here is the specs of my current motor.. 500 Watt output spindle motor The 500 Watt brushless spin...

Hi Marty,

Can you point me in the right direction as to where i can get a inverter duty three phase motor and a sensorless vector VFD?

Thanks
Dave

Hi Marty, I pulled this information out of the manual for my lathe. I will post pictures later tonight or tomorrow. 500 Watt output spindle motor The 500 Watt brushless spindle drive motor provides tremendous low-end torque. And you can vary the speed from 50 rpm to 2500 rpm continuously in both dir...

Hi Marty, If you are going with Clearpath SDSK and CNC4PC C86ACCP, have you seen and downloaded this schematic? yes Do you have basic electrical/electronic skills and can understand the schematics OK? I have some electrical/electronic skills but I may have questions once I start on my control box. I...