Centroid Community CNC Support Forum

I don't have an MC motor, it's an SDHP (high power output), with the invert statement (only used in SD) it works flawlessly with Acorn and the M codes.
I'm still working on the best way to handle the enable and e-stop. both cause program freezes when using the standard ClearCore code for the inputs ...

I believe Acorn outputs 0-10V for the VFD signal, but a cnc4pc 89 board can added to emulate a -/+ 0-10v. I haven't explored that yet.
I might have to; I don't think the Invert Polarity uses the Deceleration setting, although I'm still reading.
I could add a delay to the Invert and probably stop the ...

Thanks for the kind words, I too switched to the Arduino IDE. I started out with the Microchip Studio and was impressed with the level of detail and syntax development but, encountered quite a few errors and the terminal console is a waste of time. The new Arduino 2.0 looks promising with improved ...

I just finished the bench testing of my Acorn board with a ClearCore controller added for 0-10V analog speed control for the SDHP motor. The
analog interface board will not work on the SDSK or SDHP. I purchased the SDHP almost 2 years ago and was about to give up on the "C axis spindle",
with ...

Thanks Marty,
Thank you Peter for the information.
I'll post follow up photos as I get more of the fab work done.
I'm ready to move to the headstock riser now, that will take a few weeks to complete.

Well...I found the attachment tab finally...lol

Marty,
I believe I have resolved the issue, at least enough to move on with the build, and use PeterC's Tool logic in degrees,
and give bi-directional fast moves.
The Fedec TC10 turret's appear to be early proto types, with one home switch installed.
I removed the rear cover, removed the switch ...

Marty,
I also purchased a FADEL turret from you, I have not finished my build yet, but in setting up the lathe slides and tool plate for building the headstock riser, I've played with the turett. I needed to be able to lock the turret to measure exact tool center. I also found the same issue about ...