Centroid Community CNC Support Forum

:!this is a Cnc depot 2.2 kw ATC spindle , VFD and cable. The spindle has about 160 hours on it. The Hitachi j 200 is pre programed for S30 24000 rpm spindle.
$2200

How do I change the CSR to correct the y axis? so the angle is along Y.

Hi All, We could use some help getting our ATC working after a spindle and VFD upgrade. We are running Acorn 4.64. We build guitars. We were running a CNC Depot 530C WITH a HITACHI J-200. We just installed a CNC Depot RM50C spindle and a Automation Direct GS-23 VFD. The RM 50C does not have any outp...

working with earlier report

i am now

How to recent power surge while I had my WCS open. I thought all I lost was all my WCS Settings. I did do a restore to my last report But when I input a command like T1 M6 Nothing happens . I have acorn 5 I understand it's a parameter or somewhere in the 8 hundreds but not sure which and how to fix ...

Hi Shawn, We have discovered that our issue is a mechanical belt / backlash issue. I think we are good. Thank you so much, attached is a link to our Dropbox with all the detail that you require to help us should we need it in the future. https://www.dropbox.com/sh/5hueqarg9fvanxa/AADYvi6dzJG9ugyuTr3...

Hello All, We are in the initial stages of setting up our new CNC gantry router with using a Centroid Acorn controller. We have sent the machine home and then repeatedly back to a 1/4” reamed location hole in both the machine table plate and the 1/4” reamed hole on our fixture plate. After doing so ...

Yes I have the schematic and can read it . I have the 11805 that came with probe. I thought that 8 din plug would just plug in to the board beacuse, I am using all centroid part, At the very least, provide the male side of the plug to make your own leads. The directions did not say any thing about m...

Is there a step by step vid. of directions to hook up the DP-4 . I have acorn 12 pro v4.5 with the RV.4 board on a 3 axis router. The wiring connector they include is not near long enough to route all the way through the gantry and underside cable management to the control box. I see on the version ...