Search found 5 matches
- Tue Jun 28, 2022 7:44 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Factory Defaults
- Replies: 3
- Views: 505
Re: Factory Defaults
Reinstalling the software got me back to factory settings. I then started over following the start up videos but only got as far as the LED explication video. The axis enable led’s do not light up when running the corresponding axis. See my follow up post above “No Axis Enable LED’s” above for the c...
- Tue Jun 28, 2022 6:17 pm
- Forum: Centroid Acorn CNC Controller
- Topic: No Axis Enable LEDs
- Replies: 3
- Views: 536
Re: No Axis Enable LEDs
I ran this test with only the power and e-stop connected. All other wires disconnected. Same results
- Tue Jun 28, 2022 5:30 pm
- Forum: Centroid Acorn CNC Controller
- Topic: No Axis Enable LEDs
- Replies: 3
- Views: 536
No Axis Enable LEDs
Problem, no axis movement. Here is the history. I bought the Acorn board @18 months ago but just started the cnc build within the past few months. Installed ball screws, stepperonline stepper motors w/CL86Y drives, and rough wired the control cabinet. Went through the installation and startup proced...
- Tue Jun 28, 2022 2:02 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Factory Defaults
- Replies: 3
- Views: 505
Re: Factory Defaults
Thanks, I give that a try!
- Tue Jun 28, 2022 12:32 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Factory Defaults
- Replies: 3
- Views: 505
Factory Defaults
How do I reset my Acorn board to factory defaults?