Search found 6 matches

by kenmwallace
Wed Nov 25, 2020 10:13 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Atrump E216 DXF Import?
Replies: 3
Views: 49

Atrump E216 DXF Import?

Now that I have my CNC10 VMC running, I wanted to experiment with Intercon. I was under the impression that dxf import was a standard feature of Intercon. On my machine it does not seem to be enabled. See Screenshot. Is this something I can turn back on? This screen does not seem to allow toggling t...
by kenmwallace
Wed Nov 25, 2020 6:55 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Old M400S...Won't power up after sitting 5 years.
Replies: 9
Views: 179

Re: Old M400S...Won't power up after sitting 5 years (RESOLVED)

The Atrump E216 with CNC10 is up and running. For the record: It seems the problem was multiple poor connections in the control console. Once I could get the CPU to boot I found I was able to induce all kinds of error messages by wiggling the cables that connect to the servo board. These cables conn...
by kenmwallace
Wed Nov 25, 2020 12:41 am
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Old M400S...Won't power up after sitting 5 years.
Replies: 9
Views: 179

Re: Old M400S...Won't power up after sitting 5 years.

Thanks to all who have offered suggestions and support! I now have it up and running. There must have been a poor connection somewhere, because complete disassembly, cleaning and reassembly made it work. I am now trying to learn my way around operating it. I am hoping that the youtube tutorials for ...
by kenmwallace
Mon Nov 23, 2020 10:48 am
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Old M400S...Won't power up after sitting 5 years.
Replies: 9
Views: 179

Re: Old M400S...Won't power up after sitting 5 years.

I did reseat the PCI board as my first attempt to rectify the issue. The gold on the edge connector looked good and the board is hard to get out of the card cage due to all the cables behind it etc. I don’t know what kind of connectors the fibers use, but I was reluctant to expose them to potential ...
by kenmwallace
Sun Nov 15, 2020 11:32 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Old M400S...Won't power up after sitting 5 years.
Replies: 9
Views: 179

Re: SOME PROGRESS... Old M400S...Won't power up

Thanks for the advice about shorting the start pins on the motherboard. I did replace the battery and shorted the pins. I got it running. I also needed to press the power button on a little board I found dangling inside the console. Apparently this is the control board for the LCD monitor and needs ...
by kenmwallace
Tue Nov 10, 2020 3:21 pm
Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
Topic: Old M400S...Won't power up after sitting 5 years.
Replies: 9
Views: 179

Old M400S...Won't power up after sitting 5 years.

I have an Atrump E216 that I am trying to get going. It has control console serial number 20504 on it. The computer is a Gigabyte GA-78LMT-2SP When I apply power, the computer has not powered up successfully. I did see a message pop up for a few seconds saying that it was in a low power mode. But, a...