Search found 5 matches
- Thu May 27, 2021 9:25 pm
- Forum: Centroid Acorn CNC Controller
- Topic: EMCO PC55 mill, Servo card ribbon cable pinouts to ACORN controller
- Replies: 4
- Views: 1361
Re: EMCO PC55 mill, Servo card ribbon cable pinouts to ACORN controller
CNCKeith, THANK YOU for the QUICK reply. That is most likely the BEST route to go for long-term use if the little frame of this mill will work. I am not sure this little mill will have the travels that I need after it is fixtured and tooled up. Hoping to be able to try it out a little to prove it wi...
- Wed May 26, 2021 7:58 pm
- Forum: Centroid Acorn CNC Controller
- Topic: EMCO PC55 mill, Servo card ribbon cable pinouts to ACORN controller
- Replies: 4
- Views: 1361
EMCO PC55 mill, Servo card ribbon cable pinouts to ACORN controller
Does anyone have the pinouts from an EMCO PC55 Mills servo driver card 16pin connector? I just got my new acorn controller and am hoping to reuse the factory Driver card and 3-phase stepper motors. The factory card has a 16 pin ribbon cable input with the top wire #1 being RED. I am hoping for somet...
- Fri Nov 20, 2020 7:27 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Output Configuration Acorn CNC12 Emco Mill 55
- Replies: 9
- Views: 3377
Re: Output Configuration Acorn CNC12 Emco Mill 55
mdhubilla,
If you were able to post the connection pinouts going into the EMCO pc55 mill servo driver card when the system crashed it took that away.
When you have time please post again.
THANKS
If you were able to post the connection pinouts going into the EMCO pc55 mill servo driver card when the system crashed it took that away.
When you have time please post again.
THANKS
- Mon Nov 09, 2020 9:57 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Output Configuration Acorn CNC12 Emco Mill 55
- Replies: 9
- Views: 3377
- Sun Oct 04, 2020 12:14 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Output Configuration Acorn CNC12 Emco Mill 55
- Replies: 9
- Views: 3377
Re: Output Configuration Acorn CNC12 Emco Mill 55
Sorry I cannot help with your question, but I think you can help answer a question for me.
Were you able to use the EMCO motors that came with the mill? If not what motors and drives did you use?
I am trying to retrofit a EMCO PC 55 mill.
collinsj@buckeyehills.net
Thanks
Were you able to use the EMCO motors that came with the mill? If not what motors and drives did you use?
I am trying to retrofit a EMCO PC 55 mill.
collinsj@buckeyehills.net
Thanks