Centroid Community CNC Support Forum

CNCKeith, THANK YOU for the QUICK reply. That is most likely the BEST route to go for long-term use if the little frame of this mill will work. I am not sure this little mill will have the travels that I need after it is fixtured and tooled up. Hoping to be able to try it out a little to prove it wi...

Does anyone have the pinouts from an EMCO PC55 Mills servo driver card 16pin connector? I just got my new acorn controller and am hoping to reuse the factory Driver card and 3-phase stepper motors. The factory card has a 16 pin ribbon cable input with the top wire #1 being RED. I am hoping for somet...

mdhubilla,

If you were able to post the connection pinouts going into the EMCO pc55 mill servo driver card when the system crashed it took that away.
When you have time please post again.
THANKS

Yes
That would be GREAT!
my email is collinsj@buckeyehills.net

Sorry I cannot help with your question, but I think you can help answer a question for me.
Were you able to use the EMCO motors that came with the mill? If not what motors and drives did you use?
I am trying to retrofit a EMCO PC 55 mill.
collinsj@buckeyehills.net
Thanks