Centroid Community CNC Support Forum

So I adjusted the z- limit, ran the system test and it passed! The only issue I am left with is the z+ home position not being in the correct location for the tool changer claw. I thought I made the change correctly but it is not taking. How do I go about changing this? And if I do, do I need to rer...

Long story short i recently had an issue with my z-axis and had to take it apart and put it back together. Everything seemed fine after reassembly until I noticed the position of the spindle was not in the correct location for the tool changer claw. To correct this I adjusted the soft limits and aft...

Thank you! Everything is working again. Has anyone been able to get x-y-z axis load meters to work with DMM DYN4 servo motors?

Hi everyone after reading this post it inspired me to get my load meter working. I did follow the TSB for setting the machine parameters and in the PLC I changed the spindle axis from 5 to 6 and successfully compiled. Unfortunately now when I start my machine and reset the e-stop I can manually star...

Tblough,

Thank you for the advice, I will reconnect the mean-well power supply.

Robbie

I am in the process of putting all of my CNC components in an enclosure. In the enclosure I have 3 separate ABB power supplies 5V, 12V, and 24V. What I would like to do is connect the oak board to these power supplies and no longer use the mean-well. However upon disconnecting it I quickly grew conf...

Thank you

Attached is my report

Over the past few days I have finally been able to get my VFD wired up and configured. Everything seems to be functioning as it should except for the inverter reset. I can only get continuity between the OAK output 5 and common if I force the output but cannot get it to work using the virtual contro...

Will do Marty. thank you for all of the videos you have posted. They were very helpful in helping me get my system up and running. i am in the process of cleaning up wiring and buttoning up some things but once I get something semi-presentable I will definitely post a video.