Centroid Community CNC Support Forum

Clint’s macro uses g30 p2. Following ligelo’s advice, I changed p2 to the correct coordinates and it works as expected. Thanks again for your help!

You can use G28 / G30 / G30 P2 / G30 P3 and set to be any position you like.

Navigate as follows from main menu F1 Setup / F1 Part / F9 WCS Table / F1 Return. You now choose 1 of the 4 Return points (to match Clint's macro) and enter the appropriate co-ords remembering they are Machine Co-ords ...

Report attached

Hi. I’m using the mfunc6_clint macro.

There’s a part in the program where the tool moves to the fixed position sensor. It goes to x0,y0. I thought the settings for the position was in the wizard. But no matter what I set it to, it always goes to x0,y0. Am I missing something? Any help is ...

Hello,

I recently decided to redo my controller box and disconnected everything. I can’t remember what to connect common to. Is it the gnd connection on the power supply?? Thank you!

I figured it out! Thank you!

Can someone help explain the order in which the wires go?

I think this is the diagram for my sensors

I don’t understand how to wire this. Here’s the diagram. My sensors won’t all function when I do it the way I think it’s supposed to go.

I have the db25 breakout board on standby but haven’t tried it yet since I’m short on space. Hiya jojo, I have a couple of these right angle style DB25 breakounts on my Acorn installs. I was very short on space as well. I got mine on Amazon in 2018 but they no longer have them and they are a ...

Thanks for the help y’all. My problem can be traced back to my not understanding that the alarm on my driver is set to NO as opposed to NC. Also I didn’t know that in acorn you can change the input to detect either a NO or NC sensor.


So this issue can be called resolved?


Yes it can! Thank ...