Centroid Community CNC Support Forum

Got it!
I was attempting to setup using the touchscreen
Connected a mouse and all is good
Thanks for the help!

All but the one on the bottom (E-Stop) are not active
Is there a setting that needs to be turned on?

When upgrading software from older versions to CNC12 v5.06, is the Ether1616 board a requirement?
I updated the software and the CNC Wizard is looking for the Ether1616 to be able to setup the I/O.
Thanks

Anyone know how to get the Tool Trail to display in a 2 axis configuration?
This is on a waterjet
Tool Trail not showing
Thanks

Garnet feed system

https://www.instagram.com/reel/CLNJhs6J ... zpin13whnv

Flow 9X pump

https://www.instagram.com/reel/CLNIcs6p ... lq60ukrssy

Cummins powerplant

https://www.instagram.com/reel/CLNHQ7Zp ... 5i703iawl5

Shop built cantilever type movement Centroid Acorn CNC control Rezurection control panel by Gary Campbell Flow 9x pump with hydraulic system connected to a 45Hp Cummins power plant Makes really nice cuts Instagram post link below https://www.instagram.com/p/CLKw9uSnBfs/?igshid=jyw1z83red0z https://w...

Just finished up building our shop made Waterjet
Wanted to give a shout out to Gary Campbell for all of the help!
See Instagram link below

https://www.instagram.com/reel/CLIN1uBp ... ziwlu4f634

[/quote]

Just out of curiosity: Why do you want to run CNC12 in Tablet Mode?

-swissi
[/quote]

We were just trying it out. Switched back to normal mode and all is fine. Thanks