Centroid Community CNC Support Forum

Hi Marty and Shawn, The cable is shielded and is an extension from the exterior of the panel to the acorn (attached photo 4121), the drivers are connected to the 5V of the power supply provided by centroid. I made a 3.5 Hrs test and no problems, just noticed that the temperature of the motors is hig...

Hi Marty, This is an update, I changed the stepper drivers for a DM556T from stepperonline at 48V and set RMS current 3.1A (IAW the motor datasheet rated current 3 A) and installed a SE-600 Meanwell power supply 48V 12.5 A 600W. I'm doing some tests, so far what I noticed is that the sound produced ...

Thank you Marty for take the time to help me, this is my first project, I'll made the changes, once have all done I'll let you know.

Best regards

Leo

I'll test it with another PC, the stepper drivers are TB6600 (datasheet attached), the motors datasheet is attached as well. The power supply is a Meanwell 24V 15A.

Thank you

Leo

Hi and thank you Carboncymbal, Keith, and the master Marty, First, regarding Keith's suggestion, every time that the PC starts makes that test, and I put a lot of attention to that and I didn't detect any ping lost, should do it anyway? Second, I read all the "ghost in the machine" topic a...

Hi everyone, I have some issues with my ACORN, suddenly it lost communication, 452 Ethernet communication error, CNCP to controller, see tech ....., I exit CNN12, then start again, everything was ok, but after 2 hours of working it lost position (please see attached files), I have this ACORN about a...

Hi guys, I’m new here, I have my acorn connected to a router and I followed the recommendations described in the touch off plate topic, and my touch plate worked fine, until I was changing the connector, I didn’t turn off the machine while I was soldering the new connector (I know, I screwed up :rol...

Hi guys, I’m new here, I followed the recommendations described here, and my touch plate worked fine, until I was changing the connector, I didn’t turn off the machine while I was soldering the new connector (I know, I screwed up), now the touch plate doesn’t work, what I should do?, I checked the i...