Centroid Community CNC Support Forum

Thanks Ken i have yet to automate the atc and have a carriage in and carriage out being used for the toolholders as well as a dust boot which will pneumatcally work with carriage in and out to move it out of the way. i havent used the tool locked sensor as i figure toolrelease will lock the tool ...

All seems to work good now , i have attached my control wiring for anybody who uses this vfd in the future, not sure whether the control wiring is 100% correct but it does work

Changed my 0-10v cable and ground it and it seems ti work right now on config 110 without a potentiometer, still have fluctuation of 8 100’s of a hertz on the vfd reading and not sure if thats normal or not

there are some parameters from config. 110 which are not in config. 111 the wiring to output relay from vfd i changed from my original drawing which works on config.110 except for correct spindle speed, motor parameters were given to me from hiteco with a file i uploaded into the vfd . you can ...

Hi,Option 1
I have managed to get the acorn to control the run and clockwise of the spindle on configuration 110 but because it asks for an potentiometer with fixed 10v coming from the vfd and acorn 0-10v,where it should show 12000rpm at 400hz it is only showing 110hz and fluctuating, is there a ...

Hi I am struggling to get acorn to control my bonfiglioli vfd, i got given the motor parameters from hiteco and the spindle is spinning on configuration 110 nicely,i have tried changing the local remote parameter to both analog and digital control with no luck, i have attached my control wiring to ...

Hi , my S1 tool. Clamped correctly sensor, i dont know which definition to assign the input as i only see toolunclamped as i am unable to spin my spindle which i am trying to sort out with hiteco , not sure if the sensors all have to be assigned or not as i have succesfully wired the other senses ...

report_E415F6F96750-0708203489_2023-12-08_10-41-56.zip Scanned Document.pdf 20231017174515 3.pdf IMG_4920.jpg IMG_4921.jpg IMG_4922.jpg report_E415F6F96750-0708203489_2023-12-08_10-41-56.zip hi i am having trouble figuring out my s1 s3 sensor and s1 service output, im not sure whether they need to ...

Hi i have an hiteco atc for a router that im getting ready to install, i have 3 inputs and 5 outputs available to me which i am not sure is enough or i need an expansion board, i need to install a spindle brake , 2 solenoids , and signals for the atc which im not sure whether all sognal wiring needs ...

Scanned Document 4.pdf Hi i am getting ready to install an hiteco atc on a router and was after some info before i start, i have 3 inputs and 5 outputs available to me and was wondering if that is enough or i need the expansion board. I have a brake for the spindle which needs to be installef , 2 ...