Centroid Community CNC Support Forum

Hey guys , this is my third time working with Acorn and Clearpath servos, this time our shop already built 9x5 ft plasma table , we wanted to save up some $ a bit with the controller at first and went with PlanetCNC which turns out to be a complete garbage, so back to good old Acorn, now we already ...

sorry for the delay, here's my report.zip attached , i rewired all the connectors with ferules , verified all is well connected and in, then I ran another auto-tune routine on the Clearpath CPM-SDSK-2321S-EQN for my Z axis through USB port on it, reported no issues. Then in CNC12 config I made sure...

I did put the report last time, nothing has changed since, error is the same and i have no replies, how am i supposed get help about this?

Hey guys i can't find much info on the error I'm getting, now on two different mills both running Acorn and Clearpath servos, one is small Taig mill and other big Bridgeport type knee mill that runs Nema 34 sized servos, both give 9027 axis 3 error, but Bridgeport works and clears it while Taig thro...

Hey guys, finally back off work, so I tried MDI and it immediately cancels the job and throws Axis3 error 9027 , as someone said possible and enable issue, how do I fix this, what am I looking for? Thanks

I don't think this is the source of the problem you are having at the moment but will definitely become an issue when you try to run actual jobs on your machine: The performance of your PC is totally inadequate to run CNC12. The minimum single thread CPU performance benchmark that Centroid requests...

motors turn green right away but i have to hit cycle start to be able to jog. This is starting to sound like an "enable" issue. The clearpaths motors will fault if not enabled and you try to jog them manually. For a test, try going to MDI which will enable all axis, then try moving each a...

sorry for the delay, here's my report.zip attached , i rewired all the connectors with ferules , verified all is well connected and in, then I ran another auto-tune routine on the Clearpath CPM-SDSK-2321S-EQN for my Z axis through USB port on it, reported no issues. Then in CNC12 config I made sure ...

Hey guys, I'm new to the forum, being working on my third CNC now, second time with Acorn and Clearpath servos, I was wondering if there is a list of error codes you get in CNC12 to reference to? I keep getting random 9027 error , gives Axis 3 fault detected and it keeps running after reset button o...