Centroid Community CNC Support Forum

Wasn't able to try PP the storm we got yesterday killed my power at shop. Will try again tomorow Harry_O

I Checked thumb drive I copied variouse Mach3 files on , I color code it incorrectly, so when I was at shop testing I was actually using oll mach3 pp files. I will test tomorow midel of blizzard here in NH. Sorry y-all my old eyes not working, re-colored thumb drive believed I fixed problem. I'll le...

Yes I'm sure Its the correct PP I've been creating content for over 15 years working with several pp for building mostly furniture. That is the part of it I'M very good at, however reading code is not anything I'm good at UGH . I've tried several different files all with same type of errors, Did not...

Gary great reply time, I used the Centroid Post Proccesor In V-Carve Pro.Version 10.5, Only 2 choices inch or metric .I have had problems every step of the way with Acorn so not surprised Thanks Again Harry_O

When I load cut files from V-Carve Pro using Centroid PP and try to run I keep getting error for G91.1 . Don't know how to customize PP can someone give me a PP that works? This would be greatly appreciated Thanks Harry_O

Mousecnc yes your right but i'm running full 7 amp no resiter needed. I've done that on all setups never had a problem, i'm useing much lager motors 900 oz/in and larger. been buzy working on other project . After reading over manual the db25 uses diferential wireing ,the G203v use only step directi...

Hey Guys Still no power at shop, In morning I will re read all post and gather my ideas Thanks Marty for comment Harry-O

Yes martyscncgarage I have all manuals for all components I've used at shop both hard copy and on thumb drive. You guys will have good laugh on me ,I don't use these forums much other than for reserch , I'm able to figure out things mostly on my own. hers joke I don't know how to post well don't kno...

mousecnc Yes I just figured that out after hooking up all four drivers , Gecko sent me some fuse resister. I haven't replaced them yet waiting to figure out the com problem to due all at once. I lost power to shop just after taking pictures. Take Power camp about 3 to 4 hrs to get back. Happen a lot...

PMDX 1 Shows PMDX-134 Brd mounted to two G203v drives using mail pins on driver press fit onto bottom of brd with female connector. Terminal biock are removed from g203v drivers to get at pins.Block are used later to attach motor wires to then press fit onto male pins on PMDX 134 Brd. Top R shows J6...