Centroid Community CNC Support Forum

Thank you

Is there a way to adjust the amount of X retract be for it goes back to the start position when threading using Intercon lathe.

Hello Marty I am currently using Oak with dyn4 drives and motors for my lathe. I am run CNC 11, 220 singe phase for both drives and motors. I made up my own cables as DMM did not offer them at the time. I have not seen the issues that you are having in my system with the index pulse, I am able to cu...

Hello Marty
Have any new updates with your Oak and dyn4 drives.
Thanks Ty

Hello Marty
With logic power on and powering motors with contractor when you cycle Estop, Do you see small change in X or Z axis in the dro.
Thanks Ty

Hello Marty
I am using Dyn4 drives and motors with Oak. I looked at my PID and my index markers only show once every revaluation and no flashing sporadically.
I am using 240 volt to power my drives. The logic power is always on or I get errors When I release E stop power then go to my motors.

Thanks cncsnw
parameter 242 bumped it up to 60. Cuts threads at 1100 rpm with no grove at the end.

Here is a report and the Intercon thread program I used. I can cut nice threads just a the end of the thread it seems to stop before it retracts out of thread and leaves a grove at the end kind a like a relief cut.

Hello I am run Oak with Dyn4 servos. When cutting threads G76 it doe's not retract all the way out at the end of thread and leaves a groove before it retracts and returns to the start point for next cut. I have play with spindle speed slow or fast makes no difference and used different chamfer amoun...

Hello
yes you have to use the db25 for DG4-16035 I was running them with acorn. Used servo config for setting and tuning they worked fine.