Search found 5 matches
- Sat May 08, 2021 11:39 am
- Forum: Centroid Acorn CNC Controller
- Topic: Mill Choice PM-728VT or PM-833VT
- Replies: 5
- Views: 1961
Re: Mill Choice PM-728VT or PM-833VT
I also have a PM-728VT and rigidity has most often been the limiting factor when trying to optimize toolpaths. I've done some small parts in tool steel with it but it's a struggle. There's a pretty small window of useable feeds and speeds between just rubbing and chatter. I've had a lot more luck wi...
- Mon Oct 12, 2020 3:00 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Flickering UI after probe disconnect
- Replies: 7
- Views: 2696
Re: Flickering UI after probe disconnect
The probe cable is permanently connected directly to the Acorn board and I disconnect it at the probe.
Black -> COM
Red -> IN1 = ProbeDetect
White -> IN2 = ProbeTripped
No probe connected: Probe connect and not tripped: Probe tripped:
Black -> COM
Red -> IN1 = ProbeDetect
White -> IN2 = ProbeTripped
No probe connected: Probe connect and not tripped: Probe tripped:
- Sun Oct 11, 2020 11:59 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Flickering UI after probe disconnect
- Replies: 7
- Views: 2696
Re: Flickering UI after probe disconnect
No, nothing at the end of the cable.
- Sun Oct 11, 2020 10:35 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Flickering UI after probe disconnect
- Replies: 7
- Views: 2696
Re: Flickering UI after probe disconnect
Odd, seems to open fine on my computer. I'll upload again and also try a different one.
- Sun Oct 11, 2020 8:19 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Flickering UI after probe disconnect
- Replies: 7
- Views: 2696
Flickering UI after probe disconnect
After using a probing cycle and disconnecting the KP-3 probe, I see graphical flickering in the UI. It seems to be any highlighted input box and the Esc menu item that flicker. This issue persists across all the menus, not just the probing/part setup menu. It doesn't seem to matter if I disconnect t...