Hi ,
I have ran system test. I had to load both files SysTest.cnc and SysTest.out I have ran a few times first 2 time ran a few lines and came up job complete no faults. Run it again came up missing parameter 1020 . I loaded the SysTest.out nothing opened in notepad. When I ran test nothing ...
Search found 3 matches
- Wed Apr 08, 2020 2:08 pm
- Forum: Centroid Acorn CNC Controller
- Topic: systest.cnc systest.out
- Replies: 7
- Views: 2849
systest.cnc systest.out
This post has been liked 0 time(s).
- Sun Apr 05, 2020 10:13 am
- Forum: Centroid Acorn CNC Controller
- Topic: DRO read just dash lines
- Replies: 2
- Views: 1260
Re: DRO read just dash lines
Thanks for your help found problem clear path motors have a home enable on their tuning screen that I had enabled
This post has been liked 0 time(s).
- Sat Apr 04, 2020 5:54 pm
- Forum: Centroid Acorn CNC Controller
- Topic: DRO read just dash lines
- Replies: 2
- Views: 1260
DRO read just dash lines
Hi ,
I have an acorn board with clear path SDSK motors using free acorn from when I purchased board years back. I can jog XYZ but the DRO does not change stays dashed lines XY and Z. My X axis runs away when I start machine. I have watched video from martyscncgarage about run away motors saying I ...
I have an acorn board with clear path SDSK motors using free acorn from when I purchased board years back. I can jog XYZ but the DRO does not change stays dashed lines XY and Z. My X axis runs away when I start machine. I have watched video from martyscncgarage about run away motors saying I ...
This post has been liked 0 time(s).