Centroid Community CNC Support Forum

As i look more into it it looks as if i am having some problems with the X as well. Yes the Y axis is paired they are all screw type and direct drive with as speed step reducer on each one.

X steps/revolutions 1600 Overall turn ratio 5.0002 Y steps/revolutions 1600 Overall turn ratio 5.00075 Z steps/revolutions 1600 Overall turn ratio 24.9635 I also have a fourth axis that runs with my Y. All these where calculated with a formula from centroid non of them have been changed this just st...

I have the centroid acorn cnc hooked up to a water jet I was running just fine yesterday when i shut it down. This morning when i came in i homed the machine in the back left hand corner i moved the cutting head toward the front of my table able and it only went about 3/4 of the way. It would no let...

We have just put the Acorn CNC Controller on a water jet and would like to know if there is any way to be able to jog Z axis while in a run program or to pause it and adjust it then continue the program. I am also wanting to know about how to adjust me off set down to about .020 and my tool offsets....