Centroid Community CNC Support Forum

Hi Guys

can anyone help me with transwering CNC12 to new PC

My old PC has died but i was able recover beckup fr licence and settings.
On new laptop i have installed CNC12 ver.5,3 but report was generated on older wersion and i dont know how to transfer it ..

I need some help because my old computer is broken, and I need to install Acorn on my new laptop.

I still have access to the old hard drive and all the folders and settings for my CNC mill, which I need to transfer to the new PC.

However, I’m not sure which files I need to transfer or where they ...

Hy guys,
I left my machine to sit a while and when I turned it on again, I found a problem.
I wanted to move 100 mm and the table moved 130mm. This is happening on all axis. so I don't assume that it is steppers.

I did check to set on steppers and I have it set to 6400 steps for rev. same as in ...

Hi thank you I did write it to the MPU.plc but with no luck. It did not work.
i guess I will have to do it with the second relay

I have a Acorn board with 8 outputs, before I had board where relays 1with8 was paired and 2wit7 . now I have new one and there are all relays controlled separately.
( I still have some relays free )
yes I know what you mean but I don't have another relay with multiple connectors... :(
could it ...

why i need it ? my spindle has air input for blowing out all coolant and stuff from getting in , but I don't want to turn it off manually every time spindle stops, so I hooked up el. switch. and I don't want to connect 12V to same relay what control fovars signal, because worrying about getting 12V ...

how to write custom m3 and m5 ?

Hey guys, do you know how to turn on two relays with one command ( M3) and then turn them off with ( m5 )?
basically, I need to turn on two relays with Sindel start and turn them off when the spindle stops...

Hi guys, ive bought swap out board,

Do you know how should I transfer all my settings and licence ?
Thanks

I found that this is an R100 resistor, I did resolder that, a fast DIY solution so will see if I fix it. but nothing there must be more damage on board than that


The resistor was probably R136 then. 0.1 ohm according to schematic.
https://files.seeedstudio.com/wiki/BeagleBone_Green ...