Centroid Community CNC Support Forum

Thanks for your reply, i was on holiday, so a slight delay from my part. It is a tool touch off that came with the machine, an air piston, with a reed switch on the shaft. The Tool touch off is configured as mechanical, if i change to conductive i get the same behavure. The PLC diagnostic shows red ...

I have this issue with a new install, this is the first machine with ATC that I convert, so i must be overlooking or misunderstanding something.

The atc change works fine until it is at the point that it has to measure the tool length. The z starts moving down, i see the visually see TT trigger, I ...