Search found 1 match
- Sat Nov 23, 2019 7:26 am
- Forum: Centroid Acorn CNC Controller
- Topic: Has anyone attempted to install Tower Signal Lights
- Replies: 27
- Views: 17124
Has anyone attempted to install Tower Signal Lights
I was wondering what outputs on the main board I could use to connect a tower signal light (or sometimes called Stack Lights). Green would show the CNC is running. Yellow would show the CNC is idle and Red would show the controller is in an alarm state. Most of these lights run on 24v so a relay ...
This post has been liked 0 time(s).