Centroid Community CNC Support Forum

The cable was marked DELTA, that is why I used the delta header, are the cables header specific?

I am using an oak board with a LC4DBRKOUT connected to an OPTIC DIRECT board on the DELTA slot to control a 5th axis. Is there a pinout for the LC4DBRKOUT or OPTIC DIRECT board? Will be using Kollmorgen drives.

Purchased an OAK controller about a year ago and I am just now unpacking it, should i update the NUC that came with it to Windows 11 before I continue?

https://www.kollmorgen.com/sites/defaul ... v%20AG.pdf

The drives are AKD-B00306. Above is link to manual.

Hoping to find out if the OAK board is compatible with Kollmorgen AKD series drives. What is the oak board's communication protocol?

Used +5VDC from power supply, got encoder feed back! Now for analog input 0 (pos) pin5 and analog input 0 (neg) pin 23 on the drive.
I am guessing pin 26 and pin 28 on the flying lead to OAK.

Drive has an encoder emulator and not sure what wires to use for earth Inc. emulation and +5V Inc. emulation.

https://www.baumueller.com/us/download/ ... nual-en-gb

Link to manual above. Currently hooked up to an Allen Bradley 8200. It is for an Electron Beam Welder. Just need to drive an X Y table.

Any one pair up the Oak Board with BUM618-12 motor drives?