Centroid Community CNC Support Forum

Hi,

Cant get motors moving, getting AL-56 code on drive. I am following TB 235 and working with drive manual to address the alarm. I have attached a report and drive config file is below.


--------------------------------------------------
Setup Wizard : DriveCM Ver 1.02
User Parameters ...

Perfect! Works great, thanks again for your support!

Report from this morning attached. Thanks.

Spoke too soon, now the wireless hand wheel is not working.

I confirmed that the present mpu.plc matched the MPG stage .src file that was sent to me. The issue was the parameter settings for P351,P354,P442 and P443. All is functioning!! Was unsure of "you'll need to assign "HandWheel_M" to a different unused memory bit" but did not seem to need to be done ...

Was using CNC12 V5.00 but updated to V5.3 today. I am not using a USB-BOB interface. Hand wheels are plugged into encoder ports 5 and 6 as pictured. I am looking for the specifics on the PLC program interaction as noted below in the cnc12 operator manual .

"Note: PLC program interaction is needed ...

After watching PLC programming videos on Centroid's youtube channel and some reading I am now able to compile successfully. Boy did I mess that one up. I set the appropriate parameters as pictured and uncommented some lines in the .src file at the mpg function section. After compiling I reviewed the ...

Cannot compile file. Where is the compile button? Unsuccessful after cmd prompt attempt and using Notepad++. What am I missing here. I'm sure its something simple.

I have wired the two mpg hand wheels pictured to the two db9 plugs and would like to use them to jog X and Y axis. Would like to keep the WMPG functional as well. I can see the feedback from one of the channels on the sixth axis. Is there available info on how to do this?

Hi,

Happy New Year!!
I switched out the Oak with new unit and all is working except for lack of license. How do i get the license for new Oak on old PC. Is there a fifth axis jog option for the VCP?