Centroid Community CNC Support Forum

Hi Chris
Just look at Direct Automation in QLD and look for a CWC mini Contactor thay go up to 11kW
and you can buy a clip in snubber (Surge Suppressor) and thay have different coil voltages.

Graeme

Marty Thank you for all the work and all content you provide. That's what this community is all about to share our knowledge.
Upnorth I hope the information helps and works for you.

Graeme

Hi Upnorth , I converted a Hercus PC200 to acorn about two year ago. I uses the acorn counter based tool turret with home sensor instruction to run my turret , There is no need to change the PLC as it will work as is, All that you need is to is add a single pole relay to turn the reveres voltage off...

Marty My Abus motinor has the same problem as Gary it happens when I in continuous and you do not have to roll or slid you finger for this to happen most of the time it is just normal touch of the button . I have not found any way to change the setting for this monitor . The other monitor (Lilliput ...

I Have Converted my Emco PC5 with acorn . While I was setting up the acorn on the bench with the lathes control panel I had the jog buttons stuck on frequently while testing . My setup is a Dell small form i5 computer and a ABUS vt168h touch monitor. I did a lot of testing on the bench and found tha...

Thanks Keith and Scott for the quick response, I thought the numbers did not match .

I haven't received the new license email yet.

Scott know need to apologise I understand how busy the centroid team must be.

Hi from down under (Australia) I purchased two Acorn boards in November to up date my emco PC 5 Lathe and small mill. I planed to buy all the hardware and bench test the boards before i purchased the pro license for mill and lathe. As it tuned out I decided to buy two rev 3 boards with pro mill and ...