Centroid Community CNC Support Forum

we run this router with parts that are nested onto one sheet so we can cut multiple parts with running just one program.
we set a block number for the beginning of each part but the tool, offsets, speeds, spindle direction and start are only at the beginning of the program.
so if we break a tool at ...

resolved
i talked to yaskawa and they asked me to switch the motor with a motor that was not a paired axis. it worked. they think the drive and motor my have a factory setting that was slightly of of tune. the motor did not seem to have any issues with the other drive. if it wasn't :D for the fact i ...

as an update to the errors. i could not find out what i had done wrong so i reloaded the plc program and put the drives back to factory settings checked all my connections and started over and every thing worked fine???????
my x axis is paired with the 4th. i did the reversal of my 4th axis in the ...

i will try that
i may be setting it up using the wrong format
i set it up using TB267 should i have used TB252 neither one says why the set it up that way

just set up a plc12 with 4 sigma 5 1kw drives and motors.
i got the drives all powered up and tuned with no problems
i have axis 1 and 4 paired and 4 is running opposite direction as these 2 motors are on either side of a gantry.
in jog i can jog the X axis and the 4th axis follows a long and turns ...

just setting up and doing a bench test on a new oak install
all went well except when i push start the analog output goes up to the correct voltage and then shuts off after about 2 seconds. i have to e-stop then hit start again and 2 seconds later it shuts off. i change the speed settings and the ...