Centroid Community CNC Support Forum

Thanks for the information. This should help me.



Jim.

I just updated the Centroid software to ver. 14.

I had not used my new centroid before the upgrade however I am sure the Intercon software is the same. Is there any way to modify the output of the program when you post it? If so where can I find the documentation?

I am using a Taig gang tool ...

After trying Spindle break again I was successful at getting it to work as the clearpath enable signal. I would still like to know where to find this information though if possible.

thanks, Jim.

I have done a bit of searching for information on this system variable. I would like to turn on a relay when either M3 or M4 is commanded. Then turn it back off with M5. I think I can just modify my macro programs for the M codes however I can't find the map for the system variables to know what ...

You would think that with what I do for a living I would have rebooted. Oh well lesson learned.

Jim.

Thanks Gary. That did the trick. That should be added into the instructions.

Jim.

I just received the wireless MPG. I am familiar with these as I have one on a Mach 3 machine and it works great.

I followed the direction shipped with the unit. When I powered up I can see that I have a wifi connection and batteries are good. That is all. I noticed on the youtube videos that there ...