Centroid Community CNC Support Forum

Has anyone had any problems with the software installer hanging on windows 10 after selecting "install anyway" in the windows defender popup? I am unable to make it to the pop up to select the control board.

I also just attached a pic with the line of code that gives me trouble highlighted. I added the parentheses to comment it out.

Thanks again,
Jo

Thanks tblough. Report is attached.

Thanks,
Jon

Hi Folks, I am trying to use intercon to generate 2d code for simple cuts. It adds a Z axis home that trips up the software since there is no Z axis. I have been manually commenting out and adding a M00 to allow me to set the quill and/or knee. Is there any work around for this so I don't have to co...

Hi Marty, The setup is a Bridgeport ez trak (1999 vintage) using the all-in-1 and original servos on x&y with original DC power supply. I believe (but have not tested) the voltage from the original DC rectified 110V power supply is quite a bit higher than the 90V rating keling sells. The thought...

Marty,

AH! Sorry, all in one controller. The Acorn link was helpful, I can dig around there.

Thanks,
Jon

Has anyone worked with keling tech Servos?

Thanks,
JonR

Good morning, Looking to upgrade my 2 axis EZ track from 2 to 3 axis. I put a centroid all in one on it a couple years ago. I have two questions I couldn't find answers to in the forum: 1. What is the recommended centroid servo torque (or centroid part number) for the typical ballscrew quill set up?...

Hi Keith, The GT05-150 scale is still in the bulletin, but not on their website. However, when I contacted them in the last few days, they currently have them, but will be discontinuing it for a "better US made version." A quick additional question: I have an acurite scale on the quill of ...