Centroid Community CNC Support Forum

DMM DYN 4 Drives and Oak Board on a Lathe I followed the Wiring diagram from Centroid and the set up for the Dyn 4 Drives per the instructions from DMM Technologies, With the DMM DRV Software I apply power to the cabinet 240V single phase Oak and Logic Power is on at this point Open CNC12 which prom...

CNCSNW I have not measured the actual voltage i am in Ohio so it probably is 240 The MDI functions are good no faults Spindle works and the encoders are communicating via the PID menu Servos fault when I attempt to jog. The DMM software says Lost phase I have an email out to DMM asking about the pha...

220V single Phase R,S Terminals
Faults out when I attempt to move the motor

I am trying to set upDMM Technologies DYN4 drives on OAK and am getting no motion from the servos The servos are currently on the bench and not mounted and when I attempt to jog them using the VFD Jog Panel after setting Home I get a drive fault The encoders have feedback in the PID menu. I think th...