Centroid Community CNC Support Forum

Thanks I knew I did something stupid . That fixed it .

I am trying to learn intercon for my lathe but I am having an issue I can't figure out . On a turning cycle it will rapid to where the cut stops back cut to where the cut I thought would start then cut to where it should stop but not rapid back To the starting point. So my question is what have I en...

Ok thanks.

I am trying to convert a pm1236t too cnc and am in the design stage . But can't figure out what to home z off of . Do I home it off the tail stock or a fixed point on the lathe bed. If I home it off the bed it could crash into the tail stock limit switch but if it's off the tail stock I'll have to r...

Thats great I will look into that

Once the estop (input)is triggered all outputs will toggle off When an Estop/fault occurs, all outputs are turned off, they are not active. Are you saying you have outputs active? Neither the hardware, nor CNC12, automatically turns off PLC output requests in response to a Fault or E-stop. That is ...

martyscncgarage wrote: ↑Tue Apr 13, 2021 5:58 pm Boy, you sure move fast in your video....
Please post a FRESH report. Lastest version of software. Previous versions no longer supported.

Did you do any PLC modifications to those outputs?

No PLC mods
heres the report thanks

You say "those 4 outputs stay on just those 4 outputs" WHICH output numbers? and what are they assigned to? Outputs are physical outputs on Acorn. Please open the diagnostic screen. Do a video and show the outputs. Second line down is the output line, far left starts with Output 1 Show th...

Going back to 4.5 didn't fix the estop issue about turning off those 4 outputs,. So you will need to design a relay circuit with one latching relay and a regular relay to prevent pressing the estop twice from turning it back on and causing a crash The drawbar works with a latching relay , its the o...

This one is resolved