Centroid Community CNC Support Forum

Been using the Acorn with clearpath servos all working well, the only issue I have is that I can't get the Z axis to rapid move.
In the wizard the maximum speed seems set to 150, is this correct? I am engraving 800 parts and the z axis speed is slowing the cycle down. Can the Z axis speed be ...

Fixed the problem. I removed all the wiring and rewired it. I missed something but don't know what.
Thanks

I bought the molex ended cable from teknic. I cut off the molex because there is no stock in the uk for a matching plug. all the colours are the same.
Very strange. I also tried a stepper driver and I had to swap them around to. But it does work. Just happy that I have had to swap the wires.

I did follow the schematic in the first place but I could not get it to work.

Thanks. The first axis on the acorn H2 connector has the step & direction outputs to the servo drive. on the clearpath it shows that the step input is on
black wire labelled input B+ and the B- it shows as yellow.A video on youtube link here https://www.youtube.com/watch?v=CVuNCYhxudI&t=6s
Shows ...

Running an Acorn but to get the steppers or clearpath to work I have to swap out the step wires. I mean yellow going to step only works when common is connected to step and the step wire connected to ground. Looking at a video online he has his working the correct way round.
Any idea's Thanks.

Does anyone have information on the pinouts on the CN1 connection of a Yaskawa CPCR-01-SD1B?

Does the cnc software run on 64 bit pc. On all the specs I see no mention of 32 or 64 bit
Thanks

Fixed in5 not connected

Acorn coming up with 9031 drive fault even if set to bench test. Any idea's?
Thanks