Centroid Community CNC Support Forum

cnckeith wrote: ↑Wed Apr 17, 2024 4:44 pm haha.. ok how about i just delete this thread to save you from any embarrassment.

and thanks gary for all your help and input!

This thread can be ignored as 2 errors were found:

1) PICNIC error (problem in chair, not in computer

2) ID 10 T error: ID10T in control.

The reason the Drive Alarm was not active was because the operator was not enabling the motors prior to the test.

Guys... This issue was first noticed in v5.08 release and it has reappeared in this RC #6. After initial install and setup an input (#6 in this case), set to "DriveOk" works as expected for a while, but then stops working. I haven't tried a clean install as I wanted to wait in case there w...

M68 to activate, M88 to deactivate

Installation of beta RC#6 has solved this issue. Thanks for all your replies.

I would say that mine (5.08) does not operate that way. Which is what I've been asking for in this thread.

Scott, Keith....
What is the state of the reset button when either the DriveOk or SpindleOk inputs are tripped?

If your drives are 45khtz max, you should reduce the step pulse frequency even farther. The step pulse frequency sets the width (in usec) of the step pulse. For each pulse you will have an equal or greater (depending on speed) void between pulses. For example, at 100khtz this calculates to 1,000,000...

Yes. And another set to SpinREV will be controlled by M4 and M5. These are all covered in the manual, it will benefit you to spend some time there.

In the wizard, set the output that the motor is connected to as: "SpinFWD"

1) Cycle estop does NOT clear reset. Reset must be pressed twice to reactivate NoFault Out 2) I do not want to create any custom buttons 3) These are ClearPath systems using AVID or CNC Depot spindle modules, so neither of those resets re being used Has anyone loaded my report? Something's wierd Her...