Centroid Community CNC Support Forum

What voltage does the brake require for release? Are you using the same transformer that Milltronics used for the release?

Milltronics used abec 3 angular bearings on the ballscrews. I always replaced them with abec 7 bearings which are about .100 thicker.
Where do you have the z axis brake connected? If I remember right Milltronics had it connected to the estop relay.

What toolchanger does your machine have?

What are the best terminal blocks? Screw, spring, or lever?

cnckeith wrote: ↑Sat Feb 04, 2023 7:30 pm

converterking wrote: ↑Fri Feb 03, 2023 10:35 pm The rapid override independent of feed override would be my favorite.

This is available currently

You can add a 2nd potentiometer for rapid override in addition to the potentiometer for feed rate override and use them at the same time?

The rapid override independent of feed override would be my favorite.

In your cam settings, increase the min radius to a large amount like .250. See if that makes a difference.

You can make the following modification to the onCyclePoint function in the post to output the dwell time with the tapping cycles. You will need to add the code to the 'tapping', 'left-tapping', and 'right-tapping' cases. case "tapping": if (!F) { F = tool.getTappingFeedrate(); } writeBloc...

Thank you Marty and Keith. I bought the wireless mpg and paid $139 for the software unlock. I just want to try it and see if I like it. I will upgrade to 4.16 later.

Unless I missed it that link is for 4.16.