Centroid Community CNC Support Forum

One thing that I'm wondering. The PID (centroid side) is that purely for delay in drives or is that also a PID position-wise (running over the Delta PID)? Delta takes care of the PID, EtherCat runs in position mode. Centroid Drive Delaty Autotune is only for the Drive Delay calculation and has noth...

Greetings, I'm having a problem with CNC12 Acorn Router V5.08. It is similar to a problem I had with the previous version which was V4.8. With V5.08, the Wizard page for Axis Squaring resets and loses my settings. It first happened last week. All my macros were off. Once I discovered that the Axis ...

nope, you can do either, users that want to save on input use HomeAll other that don't using the individual home input definitions

What exact model ASDA-B2 drives do you have? It will say on the nameplate sticker. Please post a picture of the connector and nameplate sticker if you can. I am curious because all of Delta's documentation for ASD-B2-xxxx-B (standard spec) drives shows a 44 pin CN1 connector. The ASD-B2-xxxx-F spec...

ok sounds like we are taking about probing and not digitizing )

sounds like you just need to locate these features relative to another point on the object. then you will know where to place the geometry in the cad model. this is pretty easy.

try to keep the kit under $250, its tough these days!

SIGMA 2 SYSTEM ??? acorn centroid with delta asda-b2 wiring system problem . went cnc 12 and acorn is open , and I power up the the motor drive the x and z (only 2 axes are powered up for now) the motor start moving by it self. What rough with acorn??? hi, disconnect all but one delta drive from th...

you'll have to try it or ask the guy who wrote the post! i don't use Fusion.

Hickory/Delta ASD-B3A-E and B3-E Setup & Tuning Guide

https://www.centroidcnc.com/dealersuppo ... ds/330.pdf