Centroid Community CNC Support Forum

Probably a little late to be asking this, but will the v5.20 release include a router-specific version of CNC12 for Oak/Allin1DC/MPU11? Nope, Acorn, AcornSix and Hickory only for the new CNC12 Router version. (i'll see about that for oak/ain1/mpu11 in v5.3) draft release notes for v5.20 are attache...

djbeede wrote: ↑Mon Oct 14, 2024 4:00 am

cnckeith wrote: ↑Mon Oct 07, 2024 2:22 pm we should have a v5.2 release candidate very soon, tomorrow most likely.

Any new guesstimate for when v5.2 will be available?
Thanks!

i'm about to post a CNC12 v5.20 RC4 (release candidate #4 ) publicly, working on it now. Lots and Lots of stuff in this one!!!

VCP auto generated when Wizard is set to Horizontal Rear

VCP auto generated when Wizard is set to Horizontal Front

use the Wizard to configure the lathe cnc setup and the VCP jogging buttons will be correct. the Wizard will make the VCP jogging buttons the way you need them. if you are a newbie, don't edit the VCP unless you have the Wizard setup properly first. otherwise big chance of digging a hole for yoursel...

bucky wrote: ↑Wed Oct 09, 2024 7:13 pm Smoothing seems to make it way worse and can't even get 50 ipm without jerky movements.

the cpu single core rating is fine.

post the offending g code program

I just upgraded to acorn 5.1 and am wondering if there is a way to control the size of the tracing dot on the graph while running a job. It is currently quite large and obstructs the adjoining lines Thanks Jim the 'dot' is a representation of the tool diameter being called and used by the g code pr...

did you reset the drive to factory defaults BEFORE setting the Centroid provided Delta parameters? The drives were brand new when I put the parameters in. I also checked them again the other day against the application note. The drive parameter file is attached in a previous post. The drives are wo...

ShawnM wrote: ↑Mon Oct 07, 2024 3:53 pm

cnckeith wrote: ↑Mon Oct 07, 2024 2:22 pm we should have a v5.2 release candidate very soon, tomorrow most likely.

Can you get it here before the hurricane hits me? I'd like to try it before the machine is under water or blown away.

oh jeez.

This Thread is outdated, Beta 5.19R9 is already with FRV and SSV professional made from Centroid with smooth sine curves. Uwe thanks for reporting back, making the suggestions and your contribution to the development and testing! FRV and SSV are now standard features of CNC12 with the upcoming CNC1...