Centroid Community CNC Support Forum

Thank you.

Now that I have had the Allin1DC repaired I need to somehow tell the software that I have a right to use it.

Attached is a screenshot of how the program starts up.

How do I satisfy the program?

Liviu,

That is the only report.txt I found in the report directory. It was just yesterday, however, that I put in the demo unlocks.

I will call tomorrow to do the Teamview.

Thank you.

Dave

Keith,

Here is the report.
Should I just call tomorrow to get a Teamview session? Is there a special phone number or person for whom I should ask?

Dave

Keith, This is what I have under special parameters: Special Parameters 300 0.0000 | 200 0.0000 | 201 0.0000 | 202 0.0000 203 0.0000 | 204 0.0000 | 205 0.0000 | 206 0.0000 207 0.0000 | 208 0.0000 | 209 0.0000 | 400 0.0000 401 0.0000 | 210 0.0000 | 232 0.0000 | 211 0.0000 500 0.0000 | 510 0.0000 | 21...

Keith, I put in the temporary codes and now MPU will not load. I only had time to try once, so I will shut down and reload again this evening when I get home from work. I have the Report.txt file from last "restore". Where do I find the proper verification codes in this file? You said that...

Scott,
May I have the three digit number that will unlock my software?

Dave

Scott,

OK, I tried running the System Test. I figured out that my password is "137", but when I pressed Cycle Start I was told: "Demo mode has expired. Contact your dealer to purchase permanent unlock key"

Can't you give me the unlock key?

Dave

Scott,

I found it.

Thanks.

Dave

I get this when trying to go to the web address you listed: Error 404 - Not Found

The document you are looking for may have been removed or re-named. Please contact the web site owner for further assistance.

I will go to the Ajax website and try to find the .pdf.