Centroid Community CNC Support Forum

KP-3 to ALLIN1DC - https://www.centroidcnc.com/centroid_di ... term=15294

KP-3 to OAK - https://www.centroidcnc.com/centroid_di ... term=15295

These connection points called out are for the OAK board, but the wire numbers and colors will match.

You have direction reversal on for that axis which means that the input wires must be swapped physically and the input numbers reversed as well.

I see from the MDI history that you are commanding "M37 s800" all on one line. You should instead issue two separate commands without leaving MDI.

You should command:

M37 <Press Cycle Start>

s800 <Press Cycle Start>

You can then move he laser around with the MPG while still in MDI.

Those connections were mislabeled at the drives. Thanks for pointing that out. I fixed the schematic.

https://www.centroidcnc.com/centroid_di ... term=15200

You should set both DRO and Machine units the same to avoid confusion.

With you current settings the machine will run in inches and display in metric...If you command "G0 x1" in MDI right now the machine will rapid to 1 inch and the display will show" X +25.4"

All your metric jobs will need a ...

A corrected schematic has been uploaded. Thanks for catching that.

https://www.centroidcnc.com/centroid_di ... term=15147

How exactly do you have the ZRI Home wired now?
Where you able to get the OCZ output to work or are you still using the F5305S?

Corrected schematic:

https://www.centroidcnc.com/centroid_di ... term=15279