Centroid Community CNC Support Forum

That was it.

Thanks again CNCSNW!

Best Regards

Thanks again CNCSNW!

Greetings,

I've almost finished upgrading a Aciera mill from a DCIO3 to an AllinOne controller.

Can I use the wired MPG from the DCIO3 with the AllinOne system?

It is an EHDW-BA5S-IM.

If so, is there a pinout for the conversion?


Thanks

Greetings,

I've almost finished upgrading a Aciera mill from a DCIO3 to an AllinOne controller.

All has gone very smoothly. I documented all the settings from the old controller and programmed them into the new.

Only issue is feedrate when commanded by G-code. Jogging follows my settings. But ...

I unchecked the custom DB25 settings switch and relaunched. All of the axis turn the green enable LED to red.

I reselected Sigma Yaskawa settings in Axis Motor Drive Configuration. Relaunched. Now all axis are working. The green enable lights stay green.

Happy to have made progress. Curious to ...

I wired my machine to use axis 1 and 2 with Yaskawa Sigma drive. These are working nicely. I've wired a very small steppers drive to axis 3 using the 6 (step) and 7 (direction) pins of the DB25. Custom DB25 settings is one but I didn't make any changes to it.

As soon as I command axis 3 to move ...

Do I need to adjust any setting in the Wizards DB25 Signal Mapping menu.

Thanks

Is it possible on an AcornCNC to output step and direction
commands using the screws terminals for axis 1 and 2 and
the DB25 terminals for axis 3 and 4?

Thanks

Rich

I eliminated the possibility there is a wiring issue preventing my AcornSix board from driving XA, XB, and Y axes. I did this by replacing the AcornSix with an AcornCNC board. I plugged the H1 and H2 open collector connectors on the AcornSix directly into the H2 and H3 connectors on the AcornCNC. I ...

Can I send the AcornSix in for this update.