Centroid Community CNC Support Forum

Hi,

BTW, I forgot to tell you these are 2500 line encoders, and when I made a full rev of the motor, the pid screen said 10,000 which would be correct. I also checked the 5volts coming from the Ajax drive, which started out a little over 5volts, and only dropped a little with 3 of the motors ...

Hi,

I have an “all in one DC” Ajax drive and am using the Centroid software, and the Ajax jog panel.

I have 3, 1997 Hurco Hawk mills that were taken out of service for unknown reasons. The servomotors have different encoders, and I don’t know what was original, or a replacement. I looked at one ...

Hi all, my cnc runs great! just a couple of questions:

1) I have "go fasty" brush less motors with 2,500 line encoders, 10,000 counts per REV with 7.5 motor turns per inch. It runs great at rapid traverse 250 IPM. I can go 400 IPM if i want. My question is: thats a lot of encoder counts being sent ...