Centroid Community CNC Support Forum

My apologies, I'm new to the Centroid software and didn't know where that setting was. My first mill runs Mach3 which I am familiar with, the other machines use Cincinnati's software so this is my first Centroid experience. I haven't run any parts yet, but that change does appear to have eliminated ...

I tried the generic Fanuc and had the same problem, it seems any CAM program that uses G28 in their post processor code generates the same error. If I go through the code and remove all G28 references it will run fine.

George

Thanks for the reply, I'm usually pretty good at figuring out what went wrong myself. My first Boss conversion and Mach3 have been running flawlessly for about six years now, so I was getting very frustrated with this problem. I looked at the G-Code and didn't see anything that would tell the ...

When posting code from Fusion 360 or CamBam using the Centroid post processor I get this error message "Y axis travel exceeded line xxx" the line number varies depending on which program I post from. In the graph view zoomed out it shows a tool move line far to the top and left of the part which is ...

I have found some info on the spindle fault 9030 error, which get on startup, it references a jumper between INP25 and input com. Where, or what is INP25, I don't see it on the ALLIN1DC or any of the prints. I am using the original Bridgeport contacts, no VFD. This one of two upgrades I have to do ...