Centroid Community CNC Support Forum

Download new version however wizard did not load.

Watched and set controller as per Bench Test Running Motor.
Dose estop have to be wired to acorn to make light on G540 to change to green?
No change in software problem.

Machine doesn’t run at this time.

Ok

Here are photos. Will send backup at a later date when I find it.

When I press cycle starts everything is cleared and press cycle start appears again.
https://youtu.be/7TedeUdYK1I

Using Geckodrive G540

Appreciate all the feedback]. Have decided to use resistor.

What amps must motor draw to eliminate a resistor?

Thank you.

How would I make a dummy code so software dose no revert back to another loaded code?