Centroid Community CNC Support Forum

I have a question regarding VCP Buttons. I have noticed that a couple of the buttons I want to use have the same skin event number. For example, "set_x_0" and "Aux1" both share "skin event number 3" My question is: Is this going to create a conflict if I use both of the...

Hi All, I am in the process of converting my 3040 Cast Iron Chinese Router. As the title says, the specs are: 3040 Cast Iron Gantry Mill/Router (around 350lbs)(Metric 1605 Ball Screws) Acorn Board (original Rev2 board I bought before covid and never had a chance to use until now) Full ADSA-B2 Servos...

Yes. I am also using Delta ASD-B2. I got it figured out.

Thanks for the reply.

Hi @usinart. Did you happen to find a solution. I am in the same boat as you. Motors are known good as I am replacing a DDCS controller. Can jog in the ASDASOFT sowftware. All servo parameters have been reset to default and then set to Centroid's recommended parameters. Centroid Wizard has been set ...

Mike... So have you seen the amount of K.I.S.S. (read as brilliance) in those $4 opto coupled relays that I use yet? The trigger pin can be set high or low AND you can use the NO/NC relay output terminals (daisy chained into a NC feed for the input) to sort out any active/non-active logic from diff...

I am also going to be using a mixture of DMM dyn4 and clearpath servos for my Mill conversion and I want to try to PLC route to fix the input signals issue. I don't have any experience with PLC's however. I would just follow your lead and go with the Click PLC but I am currently living overseas and ...