Search found 8 matches
- Sun Jul 07, 2019 7:55 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Re: Part Zero Drifting while running (RESOLVED)
Cool, seems to be ok.
- Sat Jul 06, 2019 6:18 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Re: Part Zero Drifting while running (RESOLVED)
Sorry it took me so long to get back to you. I have a job that involves travel, so sometimes I can't get back that quick. Anyway what were you guys saying about the dip swithes not being set to the overall turns ratio? What should it be set to? The zero drifting part was fixed with the axis being ti...
- Wed Jul 03, 2019 1:24 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Re: Part Zero Drifting while running
I found a lead screw nut loose on the Z axis. Since I fixed that, has not been a problem.
Thanks for all the input.
KT
Thanks for all the input.
KT
- Sun Jun 30, 2019 1:57 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Re: Part Zero Drifting while running
Here are the wizard pages.
- Sun Jun 30, 2019 1:56 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Re: Part Zero Drifting while running
I did attach a report. It's under the system ID picture. Maybe it didn't go through? I will attach another along with the CPU benchmark. I will need to look at my power supplies and get back to you. I am using 2 power supplies, one is for the Acorn board the dual 5vdc and 24vdc for I/O. And another ...
- Fri Jun 28, 2019 8:14 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Re: Part Zero Drifting while running
Okay heres what I have. I made this machine myself with only a table saw and a drill press, so be kind.
All my motors and drives are the same.
Thanks for helping,
All my motors and drives are the same.
Thanks for helping,
- Thu Jun 27, 2019 8:52 am
- Forum: Buy, Sell, Trade
- Topic: Control Cabinet needed
- Replies: 1
- Views: 4427
Control Cabinet needed
I have a small home made CNC router that I have built. It is running with a small box that is designed for sprinkler controls and is too small. I would like to find a used panel say 24x20x8 to put my controls into. If you have an old cabinet laying around, I could use it.
- Tue Jun 25, 2019 5:42 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Part Zero Drifting while running (RESOLVED)
- Replies: 22
- Views: 8132
Part Zero Drifting while running (RESOLVED)
Hey Yall, I was running a program and at line 14287 my part zero was way off! It incrementally grew in a Z- direction. I halted the program and went MDI on it, then sent the tool to zero, and it was about 9/16" off. I reset part zero above the part, and resumed the program, while the z axis sta...