Centroid Community CNC Support Forum

cncsnw thanks. Thought i tried that size in the hole but i guess not.

1. Anyone see a problem with using the relay outputs of the Oak to drive the small din mounted control relays of the existing system?

I don't care much for 2 points of mechanical failure but this would greatly simplify the conversion and keep cable isolation close to the original design.


2. What ...

Been spending time downloading and reading the manuals for the Yaskawa Servopack and Inverter as well as the Motor Control Relays and Breakers.
The wiring on some of the devices is still a bit confusing so the odds are pretty good I will be back. The Motor Reversing Relay pack for the arm and the ...

Most of it looks pretty straightforward, but I am already starting my list of questions :)


The naming convention of the schematics vs the labeling inside the control cabinet - will be several questions there

I seem to be missing some control relays - flood coolant & lube standout. " I am pretty ...

I purchased the Hurco VM10i new over 10 years ago. It had been a very reliable machine up until about 6 months ago. The battery in the Hurco control rack died and I lost the cmos settings. I was able to repair this with a bit of help from a dealer. A couple weeks ago the system would not boot up ...