Centroid Community CNC Support Forum

Thank you everyone for the help! Got my mist coolant working.

ShawnM

Just went back and read the thread again, I guess I miss this line. Apply 24 volts to the common pole of the number 8 relay. So, I take it I need to add a wire giving 24 volts to the relay. Will try that tomorrow.

ShawnM, your post to me was not very helpful if both wires do not go to the relay, where does the second wire go? Even looking at any of the drawings to me both go to the relay. The common to the center and the other to either NC or NO side. I turned on all the relays and checked each one with my ...

ShawnM, only one wire to the relay? Where does the other wire go? I looked on the schematics and don't see anything> Can you give a link to your post about wiring the solenoid?

richardb15, tried that the other day and was not getting any readings. So now I am wonder if the relay is fried.

I have tried all these and have tried 2 different brands of valves. Green light is on the board and can hear it engage. But cannot get power out. Checking power with my voltmeter and nothing, even checking at the ends of the wires even before connecting to the valve. I am referring to drawing S15010 ...

Hello,

I am trying to setup a mist cooling system on the #8 output on the expansion board. I have the air valve wired up and have tried to wire it all possible ways. When I try to turn on Mist (M7) I can hear the board click, and the green light is on the board, but I am not getting power to my ...