Centroid Community CNC Support Forum

Yes the inputs did work at one time
The schematic that I used is S15194
The THC is installed in the Profile manager

I bought a Plasma setup a couple of months ago trying to replace a bad controller from another manufacturer. I recently ran into an issue with the THC not responding to the sensors so I connected directly to the Acorn board and they worked. Is there something more I can do to to verify the THC board ...

Thank you, I have rewired using the db25 pin connector and the motors are working.

The steppers that I am using are Automaticion Technology KL 34H260-60-4A Nema 34.
the schematic that I was following was S15179.
The motors are loose when Off but Locked when On.

Hello, I have a new acorn controller with THC that I am connecting to an existing Plasma table. I am having a issue that I am unable to make any of the steppers to move. The only thing that I can find is under the Wizard at the end of the print out it tell me to select an IO Preset Configuration ...