Centroid Community CNC Support Forum

Hi,

I found the solution !!

I must wired (2 wire mode 2) and parameter (3.02) the Durapulse GS4 in this way. The OUT7 is wired on the FWD therminal to run/stop and the OUT8 n.o. contact must be on the REV terminal of the VFD. In this way, when M3, OUT8 open and the input REV when open = FWD and ...

Hi CNCSNW,
I make all voltage test on the VFD terminal and you get right. The voltage between the FWD and DCM as for the DI3 (enable command) goes from 24 VDC to 0 when the PLC request. As the AI1 and ACM go to 2.5 V .

When I run MANUALLY, it's from VCP, but I notice that I have to press green ...

Thanks for all comment, but if I come back upper of the forum, the problem remain same.

Now, I try my first CAM program, simple face canned cycle.

But when I try to RUN it, I press START CYCLE, then confirm the tool change with START CYCLE, but the spindle don't start. A line with G4 (dwell) is ...

Hi Ken, for sure, yes, I putting back auto mode.

If I don't MDI mode ask to do before start cycle.

thanks

Ok, I do all what you suggested, and the result are:
the status window show the command, example M3 S1000 show 1000.
As you can see on the attached pictures, MEM84, MEM86, MEM87, M3_SV and OUT7 are set or unset, depend the case.
I look to the VFD (Durapulse GS4), In sourcing mode, the enable ...

Hi, I finalize my cnc milling with OAK and CNC12.

FIRST PROBLEM

Now, I try my first CAM program, simple face canned cycle.

But when I try to RUN it, I press START CYCLE, then confirm the tool change with START CYCLE, but the spindle don't start. A line with G4 (dwell) is added and then the ...

Thank you so much, I restart with the genuine .src source file, make my first hard button programming and it run great.
So now, I understand a little bit more how to integrate something else in the source file. And compile.
You help me to progress and be, a bit more confident.

Thanks a lot for your help, I progressed, I find how to compile with notepad++. Saving under name .src and compile to mpu.plc. In the notepad++. F6 and command listed in the TB294 seems to compile. But, the compilation not complete successfully, I got a lot of message about line from 3520 to the end ...

Thanks for this informations, It's my first time in this Notepad++ programming world. I find all the line to modify and save, but... stupid questions, how I can "compile" ?

Hi,
I'm looking for to add "hard button" on my operator panel, this hard-button must be assign to cycle start, cycle stop, and others kind.
What's easier way to achieve this , I use OAK CNC12 mill controller and software. The hard button are presently connected to PLCCAD1616 and I see the input ...