Centroid Community CNC Support Forum

It's fixed. After messing with it again I noticed that the pendant DRO wasn't keeping up with the the DRO on the computer display. I changed the batteries in the pendant, nothing. I then rebooted the computer and all is back to normal. There must have been something blocking the usb to function at ...

Hi All, I spent a few hours yesterday dialing in my axis overall turns ration on all three axis I now have all three axis' accurate to less than 0.0005" over 11" in the x & y and over 6" in the z (my biggest caliper is only 12" long). I don't know if I changed something when I finalized my ...

Any recommendations for a contactor that will run my 120v 1hp dust collector?

Hi all,
I need some help getting my Delta VFD hooked up to control my spindle speed. From looking at my manual I thought it was terminals AFM & ACM. I tested with a AA battery and my speed didn't change. Here are the pages from the manual. Do I have it wrong?

-Matt

Thanks! Axis' are all working! Took some time to dial in the rotations per inch to get 100% accuracy with movement. I'm back at it tomorrow, I'll relay the final numbers for all axis'. The motors sound different than they did with RichAuto controller, is this normal?

Much appreciated!

-Matt

Shawn,
Thanks for the quick response! Lucky for me I ordered a DB25 last night. If I'm reading the diagram correctly, for the x-axis I'll use pins 2 & 3, y-axis 4 & 5, ect. Then I'll pick up a terminal block to tie the 4 drives 5v terminals together with the Acorn power supplies 5v terminal? I'll ...

Hello Forum,
I'm new here and new to Acorn, CNC12 and to Forums...

I have a 2015-ish Laguna SmartShop 1 4x8 CNC router that I'm in the process of adding an Acorn Controller & WMPG-6 Pendant to. My CNC is, was controlled by a RichAuto A11e controller and 4 Yako YKA2811MA drivers (see attached ...