Centroid Community CNC Support Forum

Looking through the logs the Height for T5 is H000. I guess I missed that. I didn't even know that is possible to set a different height reference. My bad. What is the purpose of that? If I set a height for Tx, in the tool offset screen I would assume that Hx is set in the table.

I'm not sure if this is related to a previous bug.
When setting the part z zero with tool x, height offset for tool 0 is used.

In the photo, you can see that t5 was used but H0 is shown for the tool height.


In your tool library, which Height offset is set to tool 5?
Can you post a report ...

I'm not sure if this is related to a previous bug.
When setting the part z zero with tool x, height offset for tool 0 is used.

In the photo, you can see that t5 was used but H0 is shown for the tool height.

I don't know if this is the correct place to post this, but I have an issue with the "Job Run Options" -> "Search" function since updating to 5.22. The first time I use search (since starting CNC12), it works fine. The second time I happen to use it, it causes the application to crash (CNC12 exits ...