Centroid Community CNC Support Forum

I did switch the micro switches off for the limit switches and the diag screen shows them green. I did switch one to red and it did show a trip error so I switched it back. Thanks for the reply

So i got the new all the allin1dc hooked up to my mill thought i was good but when i try to move the table the servo motor ramps up on the load bar and doesnt move then creates the full power no motion error. Ive got 74.5 volts going from the capacitor to the plc .my servo motor says 140 volts 6.8 ...

Finding the correct door open on the Diag screen did the trick I had it off and thinking that would shut it off, but you actually had to turn it on. Thanks for the help I was about to go into depression mode lol.

Doing a benchtest on my allin1 dc mill and I can’t finish the test because a line comes up that the door needs shut first. I have no door switch and need to disable it. Having no luck with changing parameter 85 to a negative number don’t do anything. I’m officially stumpt. Any help will be appreciated

Just doing the voltage bench test on the allin1 dc I put in my mill and a line says I need to close the door first. I don’t have a door switch. Is there a parameter I need to shut off so I can continue my setup. Thanks

sorry i maybe have said the wording wrong on the wiring is different statement just in different locations . going from the old blueprint to the new blue print was to me different on some of the names and colors of the wires. i thought i could just swap out the wires to the new locations but seems ...

Thank you. It was a solid light , I was getting worried about not hooking up something up not correctly. I’ve been chasing down a spindle fault code error since I installed it and it won’t let me home the machine. Rechecked vfd and everything looks correct but I don’t know what to check. The hookup ...

purchased a new all in 1dc for my mill since the old all in 1dc was getting old and kinda glitchy . thought it would be a direct replacement fit but i was wrong .most of the wiring is different .i keep getting a error code number 1 on the led board saying the voltage is bad but the power supply is ...